Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in St. Louis?
Spring replacement in St. Louis typically costs $180 – $340 for one torsion spring, including the spring, the labor, and a safety check of the cables, drums, and bearings while we’re in the unit. If both springs have failed or are the same age, most homeowners replace them as a matched pair, so a pair runs about $360 – $680. That’s an estimated range for the St. Louis market; the written estimate you get before any work starts sets the final price.
It helps to know what’s actually in your garage before you call. Most homes in St. Louis have a torsion spring setup – one or two coiled springs on a steel shaft above the door – though older homes in neighborhoods like Bevo Mill, Dutchtown, and parts of Affton still have the older extension springs that run along the tracks. The two systems fail differently and price differently, which is the single biggest reason two quotes for “spring replacement” can land $100 apart. We work on what you already have, whether that’s a Clopay door from the 1990s or a newer Amarr insulated door, and we tell you which system you’re looking at before we quote it.
Key Takeaways
- One torsion spring: typically $180 – $340 estimated, installed.
- A matched pair, usually the smarter replacement: about double that range.
- Extension springs on older doors often come in under torsion spring pricing, but the safety cables and hardware usually need attention too.
- Broken cables, bent tracks, and worn rollers found during the job are quoted separately and added to the written estimate, never slipped in after.
- Estimates are free, and we answer 24/7 at (866) 942-7683.
Spring Replacement Cost Breakdown (2026)
Here’s how spring work breaks down in the St. Louis market. These are typical estimated ranges, not promises – the written estimate is what you pay.
| What’s Being Done | Typical Estimated Cost | What It Covers |
|---|---|---|
| One torsion spring, replaced | $180 – $340 | Spring, winding labor, balance check |
| Matched pair of torsion springs | About twice the single-spring range | Both springs replaced together, door rebalanced |
| Spring repair (spring still intact) | $180 – $340 | Re-tensioning, hardware, or partial spring work |
| Cable repair (often done with springs) | $130 – $250 | New cables, drums checked, safety addressed |
| Roller replacement (added to the job) | $110 – $220 | Full set of rollers, quieter and smoother travel |
| Track realignment (if the door came off track) | $120 – $240 | Tracks straightened and re-secured |
| Opener repair (if the opener took damage) | $120 – $320 | Diagnosis and repair of LiftMaster, Chamberlain, Genie, Craftsman, and similar units |
Why the spread on a single spring? Spring wire gauge, cycle life, and door weight all move the number. A standard 25,000-cycle spring on a light single-car door sits at the low end. A heavier two-car door running high-cycle springs on a Clopay or Raynor setup lands higher, because the spring is thicker, the labor is longer, and the door has to be rebalanced precisely afterward. A matched pair costs about twice a single spring because it’s twice the spring and twice the winding, and it’s the right call when both springs are the same age – if one snapped, the other is on borrowed time.
What Affects Spring Replacement Pricing in St. Louis
No two garages price the same, and in St. Louis the differences come down to a handful of things:
- Door weight and size. A single-car door with a lightweight steel skin takes a lighter spring than a double-car insulated door. If you’ve upgraded to an insulated door from Amarr or Clopay, expect the springs to sit at the higher end of the range – the spring has to carry more.
- Torsion vs. extension springs. Torsion springs cost more to replace but last longer and fail more safely. Extension springs on older doors are cheaper to swap but need safety cables, and without them a broken spring can swing through the garage. Many homes in older St. Louis neighborhoods like Tower Grove South and Southampton still have extension setups.
- One spring or two. Many two-car doors use a pair of springs, and if one fails the other is usually the same age. Replacing the pair is about double a single spring but saves you a second service visit and a second labor charge down the road.
- What else the door needs. A snapped spring often exposes worn rollers, frayed cables, or a bent track. Anything beyond the spring is quoted line by line, so you see it before you approve it.
- Opener condition. A door that’s been fighting a broken spring can stress the opener. If your LiftMaster or Chamberlain opener started making noise or stopped lifting cleanly, that’s a separate diagnosis, and we handle openers and doors together so you don’t need a second company.
- Access and ceiling height. Low-clearance garages and tight ceiling space take more time to work safely. Standard St. Louis basements and attached garages are usually straightforward, but older detached garages in places like Kirkwood or Webster Groves sometimes need extra care.
One local reality worth naming: St. Louis summers are humid and winters swing hard between thaw and freeze. That cycle runs a garage door through a lot of expansion and contraction, and springs that are already near the end of their cycle life tend to snap on a cold morning. Humidity also works on steel springs and cables, which is why we check cables and drums whenever we’re in the unit.
How to Save on Spring Replacement
You don’t need to chase the lowest quote – you need to avoid paying twice. Here’s what actually helps:
- Replace the pair, not just the broken one. It looks like more today and costs less overall. Two same-age springs means the second failure is usually not far behind the first, and that’s a second labor charge.
- Ask for the full estimate in writing before work starts. A written estimate that lists the spring, the labor, and any cable or roller work lets you compare apples to apples. We don’t add anything after the fact without your approval.
- Bundle small items into the same visit. If the rollers are worn or a cable is frayed, adding it while the door is already apart is cheaper than a separate trip. Rollers run $110 – $220, cable repair $130 – $250, both cheaper inside a spring job than on their own.
- Don’t skip the balance check. A door that’s out of balance wears its opener and its springs faster. Getting it right the first time is the real savings.
- Ask whether repair beats replacement. If your door is older and the springs, cables, and panels are all flagging, we’ll tell you honestly whether a repair is the smarter spend or whether a new door makes more sense over time. New door installation in St. Louis runs an estimated $700 – $2,200 depending on size and material.
Estimates are free and there’s no service-call charge to get a quote. Call (866) 942-7683 and we’ll book a time that works.
Is Spring Replacement Dangerous to DIY?
Yes – torsion spring work is one of the most dangerous jobs in the trade and shouldn’t be a DIY project. The springs are under extreme tension, and the winding process requires specific tools and know-how; a slip can cause serious injury. Extension springs are less tensioned but still store energy, and without safety cables a failed spring can cause damage. If you’re not sure which system you have, don’t touch it – call a trained technician.
We do the job safely, check the cables and drums while we’re in, and leave the door balanced. If you want a free estimate, call (866) 942-7683.
Can You Replace a Spring the Same Day?
In most cases, yes – spring replacement is usually a same-day repair. We keep common spring sizes on hand for the most popular door weights, so a broken spring on a standard door often gets fixed in one visit. Fast dispatch from 7am to 7pm, Sunday through Friday. Call (866) 942-7683 for an exact quote – estimates are free.
How Much Does Spring Replacement Cost in St. Louis Compared to Other Repairs?
Spring replacement at $180 – $340 (one spring) sits in the middle of the garage door repair spectrum. Here’s how it lines up against other common jobs:
- Garage door repair overall: $150 – $600
- Spring repair: $180 – $340 per spring
- Cable repair: $130 – $250
- Opener repair: $120 – $320
- Opener installation: $250 – $550
- Panel replacement: $250 – $500
- Track realignment: $120 – $240
- Roller replacement: $110 – $220
- New door installation: $700 – $2,200
If you’re weighing a repair against a new door, the math matters. A spring job on a sound door is almost always worth it. A spring job on a door with failing panels, bent tracks, and a tired opener is a different conversation, and we’ll walk you through both options with numbers attached. Call (866) 942-7683 to get a free estimate.
FAQs – Spring Replacement Cost
How much does it cost to replace a garage door spring in St. Louis?
Spring replacement in St. Louis typically costs $180 – $340 for one spring, installed. A matched pair costs about twice that range, around $360 – $680, and is usually the right call when both springs are the same age. Call (866) 942-7683 for an exact quote – estimates are free.
Is it cheaper to replace one spring or both?
Replacing both is cheaper over time. A single spring runs $180 – $340, so a pair is about double today – but if the second spring fails next year, you’ll pay a second labor charge on top of the spring. One visit for the pair almost always costs less than two separate jobs. Call (866) 942-7683 and we’ll quote both options so you can compare.
Why did my garage door spring break?
Springs break from cycle wear, not accidents. Every open and close counts as a cycle, and a standard spring is rated for a set number of them. St. Louis’s freeze-and-thaw winters stress the steel further, which is why springs tend to snap on cold mornings. Once one breaks, the door is unsafe to operate and should be looked at before you use it again.
Can I replace a spring myself?
No – torsion spring replacement should be left to a trained technician. The springs are under extreme tension and the winding process can cause serious injury if it slips. Extension springs are less tensioned but still risky without proper safety cables. Call (866) 942-7683 and we’ll handle it safely.
How much does a garage door repair cost in St. Louis?
Garage door repair in St. Louis typically runs $150 – $600, depending on the job. Spring and cable work sits in the lower-middle of that range; panel replacement or a combination of issues pushes it higher. Call (866) 942-7683 for a free estimate.
Can You Come Today?
Same-day spring replacement is often possible. We answer 24/7, so call (866) 942-7683 and we’ll get you a time. Fast dispatch from 7am to 7pm, Sunday through Friday. If you call outside those hours, we’ll book you into the next opening. Estimates are free and upfront – you’ll know the price before we start.
Whether you’re in St. Louis or a nearby neighborhood, Landon Garage Door Repair works on what you already have – LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor systems alike, door and opener handled together. Our technicians have up to 14 years of experience, and we’ll give you the right fix, not the most expensive one.
Call (866) 942-7683 for a free estimate on spring replacement in St. Louis. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Landon Garage Door Repair.
Pricing reflects the St. Louis market as of 2026. Landon Garage Door Repair offers free estimates – call (866) 942-7683.
What Our Customers Say
"Both cables had come off the drum and the door was hanging crooked. I'd watched a video and was about ten minutes from trying it myself, which the tech told me would have been a genuinely bad idea. Glad I called."
- Dana Ackerman"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Emily Anderson"The old chain drive sounded like a freight train through the bedroom above the garage. Went with the belt drive they recommended and now I genuinely cannot hear it open from upstairs."
- Cole Ziegler